Difference between revisions of "Manual Milling Class"
From Asmbly Wiki
(Created page with "{{ClassFooter}}") |
|||
| Line 1: | Line 1: | ||
| + | This class focuses on using the Rong-Fu 45 Vertical Mill as well as a lot of other tools (DO-All Bandsaw, Sandblaster, Belt Sander, and grinder). It is a required prerequisite for the Tormach class. Each student will leave the class with a key chain made in the class. | ||
| + | |||
| + | Please review the how to indicate a vise and the climb vs conventional milling video located at the link below before the class. | ||
| + | |||
| + | http://tomstechniques.com/instructional-videos/milling/ | ||
| + | |||
| + | ==Syllabus== | ||
| + | * Safety | ||
| + | * Parts of the Mill | ||
| + | * How to indicate a vise | ||
| + | * How to calculate proper machine RPM | ||
| + | * Difference between climb and conventional milling | ||
| + | * How to square a part | ||
| + | * How to layout a semi precise part with Dykem fluid and calipers | ||
| + | * How to center drill, drill, and counter bore | ||
| + | * How to mill a pocket | ||
| + | * How to use the Do-All Band-saw | ||
| + | * How to use the sandblaster | ||
| + | * How to make a leather insert on the Laser | ||
| + | |||
{{ClassFooter}} | {{ClassFooter}} | ||
Revision as of 02:49, 5 October 2021
This class focuses on using the Rong-Fu 45 Vertical Mill as well as a lot of other tools (DO-All Bandsaw, Sandblaster, Belt Sander, and grinder). It is a required prerequisite for the Tormach class. Each student will leave the class with a key chain made in the class.
Please review the how to indicate a vise and the climb vs conventional milling video located at the link below before the class.
http://tomstechniques.com/instructional-videos/milling/
Syllabus
- Safety
- Parts of the Mill
- How to indicate a vise
- How to calculate proper machine RPM
- Difference between climb and conventional milling
- How to square a part
- How to layout a semi precise part with Dykem fluid and calipers
- How to center drill, drill, and counter bore
- How to mill a pocket
- How to use the Do-All Band-saw
- How to use the sandblaster
- How to make a leather insert on the Laser
This is an active class at Asmbly. If you can't find an upcoming session in the Class Schedule, email education@asmbly.org for more information.
