Tormach Class

From Asmbly Wiki
Revision as of 02:03, 30 September 2021 by Jon (talk | contribs)

The Tormach class is taught by Eric Peterson

This class focuses on CNC milling - the Manual Milling Class or demonstrated knowledge of manual milling is a prerequisite for the Tormach class. The class is separated in to two parts:

  • Developing CAM toolpaths in Fusion 360 Manufacturing(NOTE: you will need to learn 3D modeling in Fusion on your own)


  • Tormach operation and use: (You will learn how to setup and use the Tormach and make a battery terminal clamp in the process.)


  • Cost of each class section is $100 but subject to change.


Resources


Material/Tooling Suppliers

Dixie Tool Crib (South Austin) Sparktech (Round Rock)


This is an active class at Asmbly. If you can't find an upcoming session in the Class Schedule, email education@asmbly.org for more information.