Difference between revisions of "Fiber Laser"
From Asmbly Wiki
| (7 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | {{Boneyard}} | |
| − | |||
| − | [ | + | Asmbly is in the process of building a 4'x4' CNC gantry for Danny's 1000-Watt Coherent fiber laser. We expect the tool will be ready to use in Q3 2022. |
| − | + | ||
| + | The Fiber Laser uses a Ruida controller so the workflow will be familiar to users of the CO2 lasers, but with the ability to cut steel up to 1/4" thick. | ||
| + | |||
| + | ==== End of Project ==== | ||
| + | On May 31st 2023 it was announced [https://yo.asmbly.org/t/the-fiber-laser-project-is-over/8161 via discourse] that the Fiber Laser project had been ended. | ||
| + | |||
| + | {{ToolPhoto|FiberLaser.jpg}} | ||
Latest revision as of 20:18, 16 September 2023
This tool is no longer at Asmbly Makerspace
The following information is maintained for historical purposes only. Currently operable tools are listed in the Master Tools List
Asmbly is in the process of building a 4'x4' CNC gantry for Danny's 1000-Watt Coherent fiber laser. We expect the tool will be ready to use in Q3 2022.
The Fiber Laser uses a Ruida controller so the workflow will be familiar to users of the CO2 lasers, but with the ability to cut steel up to 1/4" thick.
End of Project
On May 31st 2023 it was announced via discourse that the Fiber Laser project had been ended.
