Difference between revisions of "User:Pearlgreymusic"
From Asmbly Wiki
| (8 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Just using my personal page as a test page for the printer page template | Just using my personal page as a test page for the printer page template | ||
| − | {{Infobox 3d printer}} | + | {{Infobox 3d printer|blob |
| + | | Printer Name = Neptune | ||
| + | | Picture = NeptunePearlGreyPersonal.png | ||
| + | | Manufacturer = Grey Skies Automation | ||
| + | | Model = Neptune | ||
| + | | Network Address = http://neptune.local | ||
| + | | Nozzle Size (mm) = 0.6 | ||
| + | | Nozzle Type = Hardened Steel | ||
| + | | Nozzle Count = 1 | ||
| + | | Filament Size (mm) = 1.75 | ||
| + | | Print Volume (mm) = 220 x 220 x 300 | ||
| + | | Max Bed Temperature (C) = 100 | ||
| + | | Max Nozzle Temperature (C) = 300 | ||
| + | | Max Print Speed (mm/s) = 80 | ||
| + | | Extruder Type = Direct | ||
| + | }} | ||
Latest revision as of 03:15, 27 June 2022
Just using my personal page as a test page for the printer page template
| Status | Unknown |
| Manufacturer | Grey Skies Automation |
| Model | Neptune |
| Nozzle Size | 0.6mm |
| Nozzle Type | Hardened Steel |
| Nozzle Count | 1 |
| Filament Size | 1.75mm |
| Print Volume | 220 x 220 x 300mm |
| Max Bed Temperature | 100C |
| Max Nozzle Temperature | 300C |
| Max Print Speed | 80mm/s |
| Extruder Type | Direct |
| Manual | Unknown |
| Control Interface | Unknown |
| Network Address | http://neptune.local |
