Pearl

From Asmbly Wiki
Revision as of 04:13, 5 November 2021 by Dannym (talk | contribs)

Pearl is a Royal Mark RSX-1832. It's the same chassis as Blue (it even has ULS badges on the back) but slightly stronger at 100W and has air assist like Red.

Pearl also has a rotary fixture, so you can use it to engrave round things like glassware.

Pearl is online and bookable, but air assist isn't functional at this time (October 2021)


PearlLaser.jpg


Using Pearl Setup: Turn on chiller, wait for 22C which will take under 5 min and the chiller will auto-regulate there. The chiller must be on to run the machine. It’s not harmful to start running earlier, but its power is going to increase as temp drops and it will be inconsistent Turn on the blower, currently with a switch on a power strip. There is no protection against not doing this, so don’t. Will make automatic pretty soon

Pearl has a powered Z axis, but unlike Blue/Red, it is not controlled by driver settings. You lift or lower it to the correct location for your stock thickness and it will always run your job wherever the Z is. It will never move it automatically.

The Z is moved by panel buttons using the Z height shown on the panel's LCD. However, for some reason the Z height and/or focus keeps being incorrectly calibrated, we don't know why (possible user error), so we are NOT using this method until further notice. You need to use the stick.

To move the Z, press the "Z" button on the right:

Pearl move z.jpg

The carriage will jump to a focus location. Place YOUR stock UNDER the carriage. Locate the FOCUS STICK in a hole on the left of the bed under the lid.

Locate the RAMP on the stick, just so you understand. This is the measurement point that will contact the BOTTOM LIP of the FRONT of the carriage at the perfect focal distance. It is sloped so it does not pinch or jam against the carriage if adjusted too high, but just tips away.

Pearl focus stick.jpg

Place the focus stick ON TOP OF YOUR STOCK LOADED IN THE BED, against the FRONT of the carriage. This is shown LOW, you need to Z UP:

Pearl stick on stock.jpg






Use the Z UP/DOWN arrows to move the bed. Again, the "Z position" LCD display keeps getting changed somehow so just don't use it for now.

Pearl z display.jpg








This is now too high, the ramp tilts the stick away. Go DOWN.

Pearl z high.jpg






Pearl illustrator.jpg

Media size: DEFINED BY DRIVER

Orientation: PORTRAIT

Print Layers: ALL LAYERS

Placement: CENTER, right beside that enter X=0 Y=0

Scaling: DO NOT SCALE



If you set this differently, the job may shift a bunch in +/- X or Y, or may disappear off the workspace all together. The Preview window should appear correctly as shown, however if you did not select CENTER for PLACEMENT, it will shift your job when cutting but unfortunately will NOT appear differently on the Preview window.

“THE CATCH” of using Illustrator: every time you go to ULS’ “Setup” to change your power and print or save from there, Illustrator has been seen resetting ALL the above fields. So, reselect Portrait, Placement->Center, and change offsets back to zero after visiting the ULS setup window. If anyone knows how to keep Illustrator from reverting like this, that would be great.

When you do hit SETUP, you see the familiar ULS print driver settings:

Pearl print driver.jpg

The difference is there's no entry for Z, because it just runs wherever you left it after adjusting with the stick. PPI is now relevant, as this laser uses a pulse-mode source. 150 PPI for cutting and maybe 500 for rastering or fast engraving is a good suggested starting point.

Suggested settings 1/8" plywood 11% speed 150 PPI 0.2" plywood 8% speed 150 PPI


Maintenance

This tool is owned by Danny Miller and hosted at Asmbly for members to use. Please contact the workshop committee if maintenance is required.