Difference between revisions of "Category:3D Printing"
From Asmbly Wiki
m (New 3DP policies) |
|||
| Line 1: | Line 1: | ||
Asmbly has a growing fleet of FDM and SLA printers, with two more FDM printers slated to arrive Fall 2022 including a Prusa XL with 5 toolheads to allow for printing up to 12" square with 5 different filaments. | Asmbly has a growing fleet of FDM and SLA printers, with two more FDM printers slated to arrive Fall 2022 including a Prusa XL with 5 toolheads to allow for printing up to 12" square with 5 different filaments. | ||
| + | |||
| + | |||
| + | '''New 3DP policies effective 10/26/2023:''' | ||
| + | |||
| + | * Skedda hours booked in the 3DP categories will not count against your 25hr/wk allotment | ||
| + | * Users should now book the entire print time on Skedda, instead of setup time only | ||
| + | * Users may not utilize more than 2 printers simultaneously | ||
{{ToolPhoto|3DPrintingArea.jpg}} | {{ToolPhoto|3DPrintingArea.jpg}} | ||
Revision as of 15:47, 26 October 2023
Asmbly has a growing fleet of FDM and SLA printers, with two more FDM printers slated to arrive Fall 2022 including a Prusa XL with 5 toolheads to allow for printing up to 12" square with 5 different filaments.
New 3DP policies effective 10/26/2023:
- Skedda hours booked in the 3DP categories will not count against your 25hr/wk allotment
- Users should now book the entire print time on Skedda, instead of setup time only
- Users may not utilize more than 2 printers simultaneously
Printers currently available for members to use are listed below.
Pages in category "3D Printing"
The following 9 pages are in this category, out of 9 total.
