Difference between revisions of "Grizzly G0779 Gearhead Drill Press"
From Asmbly Wiki
| Line 4: | Line 4: | ||
{{ToolPhoto|G0779.jpg}} | {{ToolPhoto|G0779.jpg}} | ||
| + | |||
| + | ==Usage Notes== | ||
| + | *'''Only change gears when the spindle is stopped''' | ||
| + | *If a knob doesn't want to go into gear, try turning the spindle 1/4-1/2 turn. The gears should mesh nicely. | ||
| + | *If the motor's on and the spindle isn't turning, one of the knobs is between gears. | ||
==Resources== | ==Resources== | ||
| − | * [[Media: | + | *[[Media:G0779 User Manual.pdf|User Manual]] |
| − | * [[Media: | + | *[[Media:G0779 Spec Sheet.pdf|Specification Sheet]] |
| − | * [[Media: | + | *[[Media:G0779 Parts.pdf|Parts List]] |
| − | * [[Media: | + | *[[Media:H8140 User Manual.pdf|Coolant System Manual]] |
| − | * [[Media: | + | *[[Media:H8140 Parts.pdf|Coolant System Parts List]] |
{{owned}} | {{owned}} | ||
[[Category:Metal Shop]] | [[Category:Metal Shop]] | ||
Revision as of 03:26, 26 May 2022
The Grizzly G0779 is a 2hp gearhead drill press with a 23-3/8" swing and a 6-speed reversible spindle. Speeds range from 90rpm to 1970rpm. It's equipped with a recirculating coolant system.
Use of this tool is covered in all metalworking (machining or welding) classes.
Usage Notes
- Only change gears when the spindle is stopped
- If a knob doesn't want to go into gear, try turning the spindle 1/4-1/2 turn. The gears should mesh nicely.
- If the motor's on and the spindle isn't turning, one of the knobs is between gears.
Resources
Maintenance
This tool is owned by Asmbly Makerspace for the use of its members. Please contact the workshop committee if maintenance is required.
