Difference between revisions of "Grizzly G0779 Gearhead Drill Press"
From Asmbly Wiki
(Created page with "The Grizzly G0779 is a 2hp gearhead drill press with a 23-3/8" swing and a 6-speed reversible spindle. Speeds range from 90rpm to 1970rpm. It's equipped with a coolant syste...") |
|||
| (6 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | The Grizzly G0779 is a 2hp gearhead drill press with a 23-3/8" swing and a 6-speed reversible spindle. Speeds range from 90rpm to 1970rpm. It's equipped with a coolant system. | + | The Grizzly G0779 is a 2hp gearhead drill press with a 23-3/8" swing and a 6-speed reversible spindle. Speeds range from 90rpm to 1970rpm. It's equipped with a recirculating coolant system and a Palmgren cross-slide vise. |
| − | + | {{Required|Metal Shop Safety}} | |
{{ToolPhoto|G0779.jpg}} | {{ToolPhoto|G0779.jpg}} | ||
| + | |||
| + | ==Usage Notes== | ||
| + | *'''Only change gears when the spindle is stopped''' | ||
| + | *If a knob doesn't want to go into gear, try turning the spindle 1/4-1/2 turn. The gears should mesh nicely. | ||
| + | *If the motor's on and the spindle isn't turning, one of the knobs is between gears. | ||
==Resources== | ==Resources== | ||
| − | * [[Media: | + | *[[Media:G0779 User Manual.pdf|User Manual]] |
| − | * [[Media: | + | *[[Media:G0779 Spec Sheet.pdf|Specification Sheet]] |
| − | * [[Media: | + | *[[Media:G0779 Parts.pdf|Parts List]] |
| + | *[[Media:H8140 User Manual.pdf|Coolant System Manual]] | ||
| + | *[[Media:H8140 Parts.pdf|Coolant System Parts List]] | ||
{{owned}} | {{owned}} | ||
| − | [[Category: | + | [[Category:Machining]] |
Latest revision as of 14:58, 29 August 2022
The Grizzly G0779 is a 2hp gearhead drill press with a 23-3/8" swing and a 6-speed reversible spindle. Speeds range from 90rpm to 1970rpm. It's equipped with a recirculating coolant system and a Palmgren cross-slide vise.
Members must complete the Metal Shop Safety Class before using this tool
Usage Notes
- Only change gears when the spindle is stopped
- If a knob doesn't want to go into gear, try turning the spindle 1/4-1/2 turn. The gears should mesh nicely.
- If the motor's on and the spindle isn't turning, one of the knobs is between gears.
Resources
Maintenance
This tool is owned by Asmbly Makerspace for the use of its members. Please contact the workshop committee if maintenance is required.
